control action: reverse (heat) or direct (cool) modes: time and amplitude proportional control modes ; selectable manual or auto pid , proportional, proportional with integral, proportional with derivative with anti-reset windup and ooff rate: 0 to 399.9 seconds reset: 0 to 3999 seconds cycle time: 1 to 199 seconds; set to 0 for ooff operation gain: 0.5 to of span ; setpoints 1 or 2 damping: 0000 to 0008 soak: 00.00 to 99.59 (hh:mm), or off ramp to setpoint: 00.00 to 99.59 (hh:mm), or off autotune: operator initiated from front panel for 1 input at a time only outputs there are two physical outputs: output 1 = rh, output 2 = temp functio are set up as outputs ( pid or ooff), or alarms ordering output choices: relay: 250 vac @ 3a or 30 vdc @ 3a (resistive load); form c spdt ssr: 20 to 265 vac @ 0.05 - 0.5a (resistive load); continuous dc pulse: non-isolated; 10 vdc @ 20 ma (used with external ssr ) analog output(output 1 only): non-isolated, control or retramission 0 to 10 vdc or 0 to 20 ma; 500 ohm max, accuracy is ±1% of fs control output 1 and 2 operation: action: reverse (heat) or direct (cool) modes: time and amplitude proportional control modes ; selectable manual or auto pid, proportional, proportional with integral, proportional with derivative with anti-reset windup and ooff alarm 1 and 2 (programmable) 1) alarms are used for color changing sequence of alarm status (visual alarm). 2) alarm functio are active, in addition to the color changing functio, if output 1 & 2 are (menu) disabled. 3) if alarms are disabled, output menus (pid or ooff) are active. color change is still active. operation: high/low, above/below, band, latch/unlatch, normally openormally closed and process/ deviation ; front panel configuratio -al limit alarm version: output 1 & 2 submenus used for pid are eliminated from menu. color sequence based on alarm setpoints is still available. input
详细介绍
合肥永准仪器仪表有限公司其他商品